1
1
Installation
Point can be configured to run on a single computer or a network configuration of more
than ten workstations. Your office configuration determines which Point installation
process to use.
Point offers the following three types of installations for different Point configurations:
Typical or upgrade
A typical installation is used with a standard configuration for a standalone
computer.
Custom
A custom installation is used on networks of up to nine computers. During a
custom installation you specify a location for the Point template directory and
default data folder. Use this installation to enable or disable Point components.
Administrative
An administrative installation is used on networks of ten or more computers. An
administrative installation installs a tool that is used to set up a server for remote
configuration and automated client updates.
You will need your account ID to complete the installation process.
Before you begin the installation process, close any open applications.
Operating requirements
System requirements
The following system requirements are needed to install Point:
In this topic
• Operating requirements
• Prerequisites
• Typical installation
• Advanced installation
Important
Your account information is e-mailed to the primary account holder.
Component Version
Processor speed • Microsoft Windows Vista: 800 MHz (or higher)
• Microsoft Windows XP: 400 MHz (or higher)
Memory (RAM) • Microsoft Windows Vista: 512MB, minimum
• Microsoft Windows XP: 128MB, minimum
To Next Page
Loading...