Calyx Point 7 - Installing Point on the Client Workstation

Point User Guide 13
Advanced installation
h To install Point Administrator during the client installation, select the Install Point
Administrator
check box.
3 If your network uses the Point Data Server, complete the
Point Data Server section.
a Select the
Enable Point Data Service check box to enable the server.
b Enter the Point Data Server URL.
c Enter the Point Data Server Security key.
4 When you are finished setting the company and server settings, click Save Settings,
and click Exit.
Installing Point on the client workstation
After the network installation and the server configuration are finished, a one-time
installation must be completed on each client workstation. Subsequent client updates are
done automatically from the server when it is updated.
To install Point on the client workstation:
1 From the Windows Start menu, select Start > Run.
2 In the
Run dialog box, click Browse to locate the directory that you specified in Step 6
on page 11, and click Open.
3 Double-click Setup.exe and click OK to run the setup.
The InstallShield Wizard configures the Point installer and checks for any missing
prerequisites.
Related information
• Refer to Creating new data folders, on page466, for information
about creating and setting up data folders.
• For more information about Point Data Server, see
www.calyxsoftware.com, or view the Point Data Server page at http/
/:pdsb.calyxsupport.com.
Important
You must have administrator privileges to perform this setup.
Tip
Windows Vista users type Run in the StartSe arch field.