Digi IX20 User Manual

System administration Schedulesystem maintenancetasks
IX20 User Guide
1040
This optionsisonly available if Central Management is disabled; see Central management for
more information.
(config)> system schedule maintenance modem_fw_update true
(config)>
6. (Optional) Configure automated checking for device firmware updates:
a. Device firmware update check is enabled by default. This enablesto automated
checking for device firmware updates. To disable:
(config)> system schedule maintenance firmware_update_check device
false
(config)>
b. Set how often automated checking for device firmware should take place:
(config)> system schedule maintenance frequency value
(config)>
where value is either daily, weekly, or monthly. daily isthe default.
7. Save the configuration and apply the change
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
7. (Optional) Configure automated checking for device firmware updates:
a. Device firmware update check is enabled by default. This enablesto automated
checking for device firmware updates. To disable:
(config)> system schedule maintenance firmware_update_check device
false
(config)>
b. Set how often automated checking for device firmware should take place:
(config)> system schedule maintenance frequency value
(config)>
where value is either daily, weekly, or monthly. daily isthe default.
8. Save the configuration and apply the change
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi IX20 Specifications

General

Category	Wireless Router
Cellular Connectivity	4G LTE
Ethernet Ports	4
Wi-Fi	802.11ac
SIM Slots	2
WAN Ports	1
LAN Ports	3
Weight	0.5 kg
Operating Temperature	-40°C to +70°C (-40°F to +158°F)