Digi IX20 User Manual

Monitoring intelliFlow
IX20 User Guide
1057
 Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a group:
(config)> add monitoring intelliflow groups end
(config monitoring intelliflow groups 1)>
4. Set the domain name:
(config monitoring intelliflow groups 1)> domian digi.com
(config monitoring intelliflow groups 1)>
5. Set the group name:
(config monitoring intelliflow groups 1)> group Digi
(config monitoring intelliflow groups 1)>
6. Add another port:
(config monitoring intelliflow groups 1)> add .. end
(config monitoring intelliflow groups 2)>
7. Set the port number:
(config monitoring intelliflow groups 2)> domain devicecloud.com
(config monitoring intelliflow groups 2)>
8. Set the service type:
(config monitoring intelliflow groups 2)> group Digi
(config monitoring intelliflow groups 2)>
9. Save the configuration and apply the change
(config)> save
Configuration saved.
>
10. Typeexit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi IX20 Specifications

General

Category	Wireless Router
Cellular Connectivity	4G LTE
Ethernet Ports	4
Wi-Fi	802.11ac
SIM Slots	2
WAN Ports	1
LAN Ports	3
Weight	0.5 kg
Operating Temperature	-40°C to +70°C (-40°F to +158°F)