Diagnostics Configureoptionsfor theevent and system logs
IX20 User Guide
1093
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) To change the heartbeat interval from the default of 30 minutes, set a new value.
The heartbeat interval determines the amount of time to wait before sending a heartbeat
event if no other events have been sent.
(config)> system log heartbeat_interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number{w|d|h|m|s}.
For example, to set the heartbeat interval to ten minutes, enter either 10m or 600s:
(config)> system log heartbeat_interval 600s
(config)>
To disable the heartbeat interval, set the value to 0s
4. Enable preserve system logsfunctionality to savethe current session'ssystem log after a
reboot. By default, the IX20 device erases system logs each time the device is powered off or
rebooted.
Note You should only enable Preserve system logstemporarily to debug issues. Once you are
finished debugging, immediately disable Preserve system logsto avoid unnecessary wear to
the flash memory.
(config)> system log persistent true
(config)>
5. (Optional) To disable event categories, or to enable them if they have been disabled:
a. Use the question mark (?) to determine available event categories:
(config)> system log event ?
Event categories: Settings to enable individual event categories.
Additional Configuration
---------------------------------------------------------------------
----------
arping ARP ping
config Configuration
dhcpserver DHCP server
firmware Firmware
location Location
To Next Page
Loading...
Need help?
General