Diagnostics Configureoptionsfor theevent and system logs
IX20 User Guide
1095
iii. To change the statusinterval:
(config)> system log event dhcpserver status_interval value
(config)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set the statusinterval to ten minutes, enter either 10m or 600s:
(config)> system log event dhcpserver status_interval 600s
(config)>
6. (Optional) See Configure syslog servers for information about configuring remote syslog
servers to which log messageswill be sent.
7. Save the configuration and apply the change
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
To Next Page
Loading...