Interfaces WideArea Networks(WANs)
IX20 User Guide
120
6. Toggle off Enable to disable SureLink.
7. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change to the WAN or WWAN's node in the configuration schema. For example, to disable
SureLink for the Modem interface:
(config)> network interface modem
(config network interface modem)>
4. Disable SureLink:
(config network interface modem> surelink enable false
(config network interface modem)>
5. Save the configuration and apply the change
(config network interface my_wwan surelink)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Disable the default DNStest
Alternatively, you can disable the default DNStest for devices that use a private APN with no Internet
access, or that have restricted wired WAN connectionsthat do not allow DNSresolution, and
configure alternate test.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
To Next Page
Loading...
Need help?
General