Digi IX20

Interfaces WideArea Networks(WANs)
IX20 User Guide
144
iii. For Interface, select Interface: WWAN_Public.
g. Click the  to add another route policy.
h. For Label, enter Route through private APN.
i. For Interface, select Interface: WWAN_Private.
j. Configure the source address:
i. Click to expand Source address.
ii. For Type, select Interface.
iii. For Interface, select LAN2.
k. Configure the destination address:
i. Click to expand Destination address.
ii. For Type, select Interface.
iii. For Interface, select Interface: WWAN_Private.
6. Click Apply to savethe configuration and apply the change.
 Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.