Digi IX20 - Page 172

Interfaces WideArea Networks(WANs)
IX20 User Guide
172
(config network interface my_wwan)>
b. Set the carrier:
(config network interface my_wwan)> modem carrier value
(config network interface my_wwan)>
n
iccid
Set the unique SIM card ICCID that must be in active for this WWAN to be used:
(config network interface my_wwan)> modem iccid ICCID
(config network interface my_wwan)>
n
imsi
Set the International Mobile Subscriber Identity (IMSI) that must be in activefor this
WWAN to be used:
(config network interface my_wwan)> modem imsi IMSI
(config network interface my_wwan)>
n
plmn_id
Set the PLMN id that must be in active for thisWWAN to be used:
(config network interface my_wwan)> modem plmn_id PLMN_ID
(config network interface my_wwan)>
n
sim_slot
Set which SIMslot must be in active for this WWAN to be used:
(config network interface my_wwan)> modem sim_slot value
(config network interface my_wwan)>
where value is either 1 or 2.
7. Set the PINfor the SIM. Leave blank if no PIN is required.
(config network interface my_wwan)> modem pin value
(config network interface my_wwan)>
8. Set the phone number for the SIM, for SMSconnections:
(config network interface my_wwan)> modem phone num
(config network interface my_wwan)>
Normally, this should beleft blank. It is only necessary to complete this field if the SIMdoes
not have a phone number or if the phone number is incorrect.
9. Roaming is enabled by default. To disable:
(config network interface my_wwan)> modem roaming false
(config network interface my_wwan)>