Digi IX20 - Page 220

Interfaces Local Area Networks(LANs)
IX20 User Guide
220
4. Set the IPaddress of the DHCPrelay server:
(config network interface my_lan ipv4 dhcp_relay 0)> address 10.10.10.10
(config network interface my_lan ipv4 dhcp_relay 0)>
5. (Optional) Add additional DHCPrelay servers:
a. Move back one step in the configuration schema by typing two periods (..):
(config network interface my_lan ipv4 dhcp_relay 0)> ..
(config network interface my_lan ipv4 dhcp_relay)>
b. Add the next server:
(config network interface lan1 ipv4 dhcp_relay)> add end
(config network interface lan1 ipv4 dhcp_relay 1)>
c. Set the IPaddress of the DHCPrelay server:
(config network interface my_lan ipv4 dhcp_relay 1)> address
10.10.10.11
(config network interface my_lan ipv4 dhcp_relay 1)>
d. Repeat for each additional relay server.
1. Disable the DHCPserver, if it is enabled:
(config network interface my_lan ipv4 dhcp_relay 1)> .. .. dhcp_server
enable false
(config network interface my_lan ipv4 dhcp_relay 1)>
6. Save the configuration and apply the change
(config network interface lan1 ipv4 dhcp_relay 1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show DHCP server statusand settings
View DHCPstatus to monitor which devices havebeen given IPconfiguration by the IX20 device and
to diagnose DHCPissues.
 Web
Log into the IX20 WebUI asa user with full Admin accessrights.
1. On the main menu, click Status
2. Under Networking, click DHCP Leases.
 Command line