Interfaces Local Area Networks(LANs)
IX20 User Guide
225
g. For Use DNS, select one of the following:
n
Always: DNSwill alwaysbe used for this WAN; when multiple interfaceshave the
same DNSserver, the interface with the lowest metric will be used for DNS
requests.
n
When primary default route: Only use the DNSservers provided for thisinterface
when the interface is the primary route.
n
Never: Never use DNSservers for thisinterface.
h. See Configure SureLink activerecovery to detect WAN/WWANfailures for information
about configuring SureLink for active recovery.
17. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new interface or edit an existing one:
n
To create a new interface named ip_passthrough_interface:
(config)> add network interface ip_passthrough_interface
(config network interface ip_passthrough_interface)>
n
To edit an existing interfacenamed ip_passthrough_interface, change to the IP-
passthrough-interface node in the configuration schema:
(config)> network interface ip_passthrough_interface
(config network interface ip_passthrough_interface)>
4. Set the interface type to passthrough:
(config network interface ip_passthrough_interface)> type passthrough
(config network interface ip_passthrough_interface)>
5. Set the firewall zone to internal:
(config network interface ip_passthrough_interface)> zone internal
(config network interface ip_passthrough_interface)>
6. Select an Ethernet device or a Wi-Fi access point for this interface:
a. Enter device ?to view available devicesand the proper syntax.
(config network interface my_wan)> device ?
To Next Page
Loading...
Need help?
General