Digi IX20

Interfaces Local Area Networks(LANs)
IX20 User Guide
226
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan
/network/wireless/ap/digi_ap
/network/wireless/ap/digi_hotspot_ap
Current value:
(config network interface ip_passthrough_interface)> device
b. Set the device for the interface:
(config network interface ip_passthrough_interface)> device device
(config network interface my_wan)>
7. Set passthrough options
8. Configure IPv4 settings:
n
IPv4 support is enabled by default. To disable:
(config network interface ip_passthrough_interface)> ipv4 enable
false
(config network interface ip_passthrough_interface)>
a. Set the IPmetric:
(config network interface ip_passthrough_interface)> ipv4 metric num
(config network interface ip_passthrough_interface)>
b. Set the relative weight for default routesassociated with this interface. For multiple active
interfaceswith the same metric, the weight is used to load balance traffic to the interfaces.
(config network interface ip_passthrough_interface)> ipv4 weight num
(config network interface ip_passthrough_interface)>
c. Set the management priority. This determines which interface will have priority for central
management activity. The interface with the highest number will be used.
(config network interface ip_passthrough_interface)> ipv4 mgmt num
(config network interface ip_passthrough_interface)>
d. Set the MTU:
(config network interface ip_passthrough_interface)> ipv4 mtu num
(config network interface ip_passthrough_interface)>
e. Configure how to use DNS: