To Next Page

To Previous Page

Serial port ConfigurePPPdial-in mode

IX20 User Guide

275

interface.

Format:

any

dynamic_routes

edge

external

hotspot

internal

ipsec

loopback

setup

Default value: internal

Current value: internal

(config)>

b. Set the zone:

(config)> serial port1 ppp_dialin zone zone

(config)>

15. (Optional) Configure the serial port to use a custom PPPconfiguration file:

a. Enable the use of a custom PPPconfiguration file:

(config)> serial port1 ppp_dialin custom enable true

(config)>

b. Enable override to override the default PPPconfiguration and only use the custom

configuration file:

(config)> serial port1 ppp_dialin custom override true

(config)>

If override is not enabled, the custom PPPconfiguration file is used in addition to the

default configuration.

c. Paste or type the configuration data in the format of a pppd optionsfile:

(config)> serial port1 ppp_dialin custom config_file data

(config)>

where data are oneor more pppd command line options. Because the optionsare passed

directly to the pppd command line, they should all be entered on a single line. For

example:

(config)> serial port1 ppp_dialin custom config_file "debug lcp-echo-

interval 10 lcp-echo-failure 2"

(config)>

16. (Optional) Configure a script that will be run to prepare the link before PPPnegotiationsare

started:

Digi IX20 User Manual

Questions and Answers: