Wi-Fi Configurea Wi-Fi accesspoint with personal security
IX20 User Guide
333
(config network wireless ap new_AP)> encryption group_rekey 600s
(config network wireless ap new_AP)>
Increasing the time between rekeys can improve connectivity issuesin noisy environments. To
disable group rekeys, set to 0. This will allow any client that has previously connected to see
all broadcast traffic on the wireless network until the Wi-Fi radio is restarted. The default is 10
minutes.
1. Assign the Wi-Fi accesspoint to a LAN interface or to a bridge. See Configure a Local Area
Network (LAN) and Configure a bridge for more information.
The accesspoint must be assigned to an active LAN, or a bridge that is assigned to an active
LAN.
2. Save the configuration and apply the change
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Edit an existing Access point
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Show available access points:
(config)> network wifi ap ?
Additional Configuration
------------------------------------------------------------------------
-------
digi_ap Digi AP
(config)>
4. Set the SSIDfor the appropriate access point:
(config)> network wifi ap digi_ap ssid my_SSID
(config)>
5. SSIDbroadcasting is enabled by default for the preconfigured access points. If SSID
broadcasting is disabled:
To Next Page
Loading...