Digi IX20 - Page 336

Wi-Fi Configure a Wi-Fi accesspoint with enterprisesecurity
IX20 User Guide
336
Required configuration items
n
Enable the Wi-Fi access point
n
The Service Set Identifier (SSID) for the accesspoint.
n
Configure security for the accesspoint to WPA2 enterprise.
n
The IPaddressfor one or more RADIUSservers.
n
The secret key for oneor more RADIUS servers.
n
LAN/bridge assignment. Once you configure a Wi-Fi accesspoint, you must assign the Wi-Fi
access point to a LAN interface or to a bridge. See Configure a Local Area Network (LAN) and
Configure a bridge for more information.
Additional configuration items
n
Determine whether to broadcast the accesspoint's SSID.
n
Determine whether to isolate clients connected to this accesspoint, so that they cannot
communicate with each other.
n
The server port for one or more RADIUS server.
n
The amount of time to wait before changing the group key.
To configure a Wi-Fi access point with WPA2 enterprise security:
 Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.