Digi IX20

Hotspot
IX20 User Guide
389
/network/wireless/ap/digi_hotspot_ap
Default value: /network/bridge/lan
Current value: /network/bridge/lan
(config network bridge new_hotspot_bridge)>
ii. Add the appropriate device. For example, to add the Digi AP Wi-Fi accesspoint:
(config network bridge new_hotspot_bridge)> add device end
/network/wireless/ap/digi_ap
(config)>
c. Type... to return to the config prompt:
(config network bridge new_hotspot_bridge)> ...
(config)>
d. Create an interface for the bridge:
(config)> add network interface hotspot_bridge_interface
(config network interface hotspot_bridge_interface)>
e. Add the new bridge to the interface:
(config network interface hotspot_bridge_interface)> device
/network/bridge/new_hotspot_bridge
(config network interface hotspot_bridge_interface)>
f. Set an IPaddress for the interface.
Note This IPaddressis not the IPaddress of the hotspot. Thehotspot IPaddress is
configured during hotspot configuration.
(config network interface hotspot_bridge_interface)> ipv4 address ip_
address/netmask
(config network interface hotspot_bridge_interface)>
g. Type... to return to the config prompt:
(config network interface hotspot_bridge_interface)> ...
(config)>
5. Create a new hotspot:
(config)> add network hotspot new_hotspot
(config network hotspot new_hotspot)>
New hotspots are enabled by default.