Hotspot
IX20 User Guide
407
c. For Subnet, type an IPv4 addressand optional subnet mask, using the format IPv4_
address[/netmask], or the keyword any.
d. Repeat to add additional subnets.
8. Click Apply to savethe configuration and apply the change.
Configure hotspot for HotspotSystem authentication from the Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new hotspot or Enable hotspot using the default configuration.
4. Set the authentication modeto hotspotsystem:
(config)> network hotspot hotspot_name auth hotspotsystem
(config)>
5. Configure HotspotSystem:
a. Set the operator name that you registered with hotspotsystem.com.
(config)> network hotspot hotspot_name hotspotsystem operator name
(config)>
b. Set the location IDof this hotspot.
(config)> network hotspot hotspot_name hotspotsystem location value
(config)>
where value is any integer. Thedefault is 1.
6. Configure the Remote Webserver to redirect the hotspot to an authentication page.
a. Set the Fully Qualified Domain name or IP addressthrough which users are redirected to
the hotspot splash screen, log in, or authentication page for the hotspot.
(config)> network hotspot hotspot_name hotspotsystem remote url value
(config)>
where value is a FQDN: Fully Qualified Domain Name or IPaddress. The default is:
https://customer.hotspotsystem.com/customer/hotspotlogin.php
b. (Optional) Set the secret key shared between the remote server and the hotspot. Thisis
optional, unless you are integrating with a cloud hotspot provider.
(config)> network hotspot hotspot_name hotspotsystem remote secret
value
(config)>
where value is the secret key.
To Next Page
Loading...
Need help?
General