Digi IX20 - Page 430

Routing IProuting
IX20 User Guide
430
(config network route policy 0)> src address value
(config network route policy 0)>
where value usesthe format IPv4_address[/netmask], or any to match any IPv4
address.
n
address6: Matchesthe source IPv6 address to the specified IPaddressor network. Set
the addressthat will be matched:
(config network route policy 0)> src address6 value
(config network route policy 0)>
where value usesthe format IPv6_address[/prefix_length], or any to match any IPv6
address.
n
mac: Matches the source MACaddressto the specified MACaddress. Set the MAC
addressto be matched:
(config network route policy 0)> src mac MAC_address
(config network route policy 0)>
10. Set the destination addresstype:
(config network route policy 0)> dst type value
(config network route policy 0)>
where value is one of:
n
zone: Matchesthe destination IPaddressto the selected firewall zone. Set the zone:
a. Use the ?to determine available zones:
(config network route policy 0)> dst zone ?
Zone: Match the IP address to the specified firewall zone.
Format:
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Default value: any
Current value: any
(config network route policy 0)> dst zone