Digi IX20 - Page 429

Routing IProuting
IX20 User Guide
429
Zone: Match the IP address to the specified firewall zone.
Format:
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Default value: any
Current value: any
(config network route policy 0)> src zone
b. Set the zone. For example:
(config network route policy 0)> src zone external
(config network route policy 0)>
See Firewall configuration for more information about firewall zones.
n
interface: Matches the source IPaddressto the selected interface's network address.
Set the interface:
a. Use the ?to determine available interfaces:
(config network route policy 0)> src interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network route policy 0)> src interface
b. Set the interface. For example:
(config network route policy 0)> src interface
/network/interface/eth1
(config network route policy 0)>
n
address: Matchesthe source IPv4 address to the specified IPaddress or network. Set
the addressthat will be matched: