Digi IX20 - Page 428

Routing IProuting
IX20 User Guide
428
n
any: All protocols are matched.
n
tcp: Source and destination ports are matched:
a. Set the source port:
(config network route policy 0)> src_port value
(config network route policy 0)>
where value is the port number, or the keyword any to match any port as the
source port.
b. Set the destination port:
(config network route policy 0)> dst_port value
(config network route policy 0)>
where value is the port number, or the keyword any to match any port as the
destination port.
n
upd: Source and destination ports are matched:
a. Set the source port:
(config network route policy 0)> src_port value
(config network route policy 0)>
where value is the port number, or the keyword any to match any port as the
source port.
b. Set the destination port:
(config network route policy 0)> dst_port value
(config network route policy 0)>
where value is the port number, or the keyword any to match any port as the
destination port.
n
icmp: The ICMPprotocol is matched. Identify the ICMPtype:
(config network route policy 0)> icmp_type value
(config network route policy 0)>
where value is the ICMPtype and optional code, or set to any to match for any ICMP
type.
9. Set the source address type:
(config network route policy 0)> src type value
(config network route policy 0)>
where value is one of:
n
zone: Matchesthe sourceIPaddressto the selected firewall zone. Set the zone:
a. Use the ?to determine available zones:
(config network route policy 0)> src zone ?