Routing Virtual Router Redundancy Protocol (VRRP)
IX20 User Guide
469
4. Click to add an interfacefor monitoring.
5. Select Interface: Modem.
6. For Priority modifier, type 30.
Task 3: Configure the IP addressfor the VRRP interface, ETH2, on device one
1. Click Network >Interfaces> ETH2 > IPv4
2. For Address, type 192.168.3.1/24.
Task 4: Configure the DHCP server for ETH2 on device one
1. Click to expand Network >Interfaces> ETH2 > IPv4 >DHCP Server
2. For Lease range start, leave at the default of 100.
3. For Lease range end, type199.
4. Click to expand Advanced settings.
5. For Gateway, select Custom.
6. For Custom gateway, enter 192.168.3.3.
7. Click Apply to savethe configuration and apply the change.
Command line
Task 1: Configure VRRP on device one
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
To Next Page
Loading...
Need help?
General