Routing Virtual Router Redundancy Protocol (VRRP)
IX20 User Guide
474
6. For Ping host, type https://remotemanager.digi.com.
Task 5: Configure the DHCP server for ETH2 on device two
1. Click to expand Network >Interfaces> ETH2 > IPv4 >DHCP Server
2. For Lease range start, type 200.
3. For Lease range end, type250.
4. Click Advanced settings.
5. For Gateway, select Custom.
6. For Custom gateway, enter 192.168.3.3.
7. Click Apply to savethe configuration and apply the change.
Command line
Task 1: Configure VRRP on device two
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
To Next Page
Loading...
Need help?
General