Revision Date Description
l
Added show surelink state Admin CLI command
to display the overall pass/fail statusof enabled
Surelink tests.
n
WAN bonding
l
Added optionsfor WAN bonding configuration to
set modesfor the bonded tunnel and for each
bonded interface.
l
Added new show wan-bondingAdmin CLI
command.
n
New configuration settingsfor LXCcontainers:
l
Start on boot to configure the container to start
when the system boots.
l
Restart timeout to configure the container to
restart if it stops.
l
Optional parametersto include optional
parameters for the container.
l
Mounted directoriesto setup shared directories
between the host filesystem and the container.
n
Added a AT&T LWM2M support setting to enable or
disable AT&T lightweight M2Mon cellular modems.
n
VPN:
l
DMVPNphase 1 spoke support with NHRPor mGRE,
including compatibility with Cisco DMVPN hubs.
l
Added support for SHA2 ciphers for IKEv2 IPsec
tunnels.
n
Disabled mDNSby default for improved cellular
performance.
n
If the devicehas a configured System >Name, it isnow
displayed on the Dashboard.
P July 2023
Release of DigiIX20 firmware version 23.6:
n
Serial port options:
l
For PPP Dial-in mode, added the Default Route
option to control whether a default route gets
added for the PPPinterface.
l
Documented the new Modem emulator mode,
which allowsserial ports to act as a dial-up modem
emulator for handling incoming AT dial-ins.
n
Advanced Watchdog options:
l
Added System >Advanced Watchdogoptionsto
all devices.
n
Digi Remote Manager support:
IX20 User Guide
5
To Next Page
Loading...
Need help?
General