Virtual PrivateNetworks(VPN) IPsec
IX20 User Guide
522
l
Set the amount of time to wait for the interfaceto connect for the first time
before the test isconsidered to have failed.
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
interface_timeout value
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set interface_timeout to ten minutes, enter either 10m or
600s:
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
interface_timeout 600s
(config)>
n
custom_test: Tests the interface with custom commands.
If custom_test is set, set the commands to run to perform the test:
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
custom_test_commands "string"
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
n
tcp_connection: Teststhat the interface can reach a destination port on the
configured host.
If tcp_connection is selected, complete the following:
l
Set the hostname or IPaddress of the host to create a TCP connection to:
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
tcp_host hostname/IP_address
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
l
Set the TCPport to create a TCP connection to.
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
tcp_port port
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
n
other: Tests the status of another interface.
If other is selected, complete the following:
l
Set the interface to test.
i. Use the ?to determine available interfaces:
(config vpn ipsec tunnel ipsec_example surelink tests 1)>
other_interface ?
Test interface: Test the status of this other interface.
Format:
To Next Page
Loading...
Need help?
General