Digi IX20

Virtual PrivateNetworks(VPN) IPsec
IX20 User Guide
525
where value is one of:
n
update_routing_table: Increases the interface'smetric to change the default
gateway.
If update_routing_table is selected, complete the following:
l
Set the number of attemptsfor this recovery action to perform, before moving
to the next recovery action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
max_attempts int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 3.
l
Set the amount that the interface's metric should beincreased. Thisshould be
set to a number large enough to change the routing table to use another
default gateway.
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
metric_adjustment_modem int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 100.
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
n
restart_interface.
If restart_interface is selected, complete the following:
l
Set the number of attemptsfor this recovery action to perform, before moving
to the next recovery action:
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
max_attempts int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
The default is 3.
l
Set the time to wait before the next test is run. If set to the default value of 0s,
the test interval is used.
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
override_interval int
(config vpn ipsec tunnel ipsec_example surelink actions 0)>
n
reset_modem: Thisrecovery action is available for WWAN interfacesonly.
If reset_modem is selected, complete the following: