Virtual PrivateNetworks(VPN) IPsec
IX20 User Guide
540
3. Edit SCEPsettings:
a. From the menu, click SCEP >General.
b. Click Enable SCEP if it is not enabled.
c. For Default enrollment password, enter a password. The password entered here must
correspond to the challenge password configured for the SCEPclient on the IX20 device.
d. The remaining fields can be left at their defaults or changed as appropriate.
e. Click OK.
4. Create an Enrollment Request:
a. From the menu, click SCEP >Enrollment Requests.
b. Click Create New.
c. For Automatic request type, select Wildcard.
d. For Certificate authority, select the CA created in step 1, above.
e. Complete the Subject Information fields. The Distinguished Name (DN) attributes entered
here must correspond to the Distinguished Name attributes configured for the SCEPclient
on the IX20 device.
f. For Renewal >Allow renewal x days before the certified isexpired, type the number of
daysthat the certificate enrollment can be renewed, prior to the request expiring. The
Renewable Time setting on the IX20 device must match the setting of this parameter.
g. The remaining fields can be left at their defaults or changed as appropriate.
h. Click OK.
IX20 configuration
On the IX20 device:
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
To Next Page
Loading...