To Next Page

To Previous Page

Virtual PrivateNetworks(VPN) OpenVPN

IX20 User Guide

552

5. If tap or tun are set for device_type:

a. Set the IPaddressand subnet mask of the OpenVPN server.

(config vpn openvpn server name)> address ip_address/netmask

(config vpn openvpn server name)>

b. Set the firewall zonefor the OpenVPNserver. For TUN device types, thisshould be set to

internal to treat clients as LAN devices.

(config vpn openvpn server name)> zone value

(config vpn openvpn server name)>

To view a list of available zones:

(config vpn openvpn server name)> firewall zone ?

Zone: The zone for the local TUN interface. To treat clients as LAN

devices this would usually be

set to internal.

Format:

any

dynamic_routes

edge

external

hotspot

internal

ipsec

loopback

setup

Current value:

(config vpn openvpn server name)>

c. (Optional) Set the route metric for the OpenVPNserver. If multiple activeroutesmatch a

destination, the route with the lowest metric will be used.

(config vpn openvpn server name)> metric value

(config vpn openvpn server name)>

where value is an interger between 0 and 65535. The default is 0.

d. (Optional) Set the range of IPaddresses that the OpenVPNserver will use when providing

IPaddresses to clients:

i. Set the first address in the range limit:

(config vpn openvpn server name)> server_first_ip value

(config vpn openvpn server name)>

where value is a number between 1 and 255. The number entered here will represent

the first client IPaddress. For example, if addressisset to 192.168.1.1/24 and

server_first_ip is set to 80, the first client IPaddress will be 192.168.1.80.

The default is from 80.

Digi IX20 User Manual

Questions and Answers: