Services Location information
IX20 User Guide
715
l
RMC: Reports position, velocity, and time.
l
VTG: Reports direction and speed over ground.
11. For TAIP filters, select the filters that represent the typesof messages that will be forwarded.
By default, all message typesare forwarded.
n
To remove a filter:
a. Click the down arrow () next to the appropriate message type.
b. Click Delete.
n
To add a message type:
a. For Add NMEA filter or Add TAIP filter, click .
b. Select the filter type. Allowed values are:
l
AL: Reports altitude and vertical velocity.
l
CP: Compact position: reports time, latitude, and longitude.
l
ID: Reportsthe vehicle ID.
l
LN: Long navigation: reports the latitude, longitude, and altitude, the horizontal
and vertical speed, and heading.
l
PV: Position/velocity: reports the latitude, longitude, and heading.
12. For Outgoing message type, select either NMEA or TAIP for the type of message that the
device will forward to a remote host.
(Optional) If NMEAis selected:
a. Select a Talker ID.
The talker ID is a two-character prefix in the NMEA message that identifies the sourcetype.
The talker IDset here will override the talker IDfrom all sources, and all forwarded
sentenceswill use the configured ID. The default setting is Default, which meansthat the
talker IDprovided by the source will be used.
b. Determine the Behavior when fix isinvalid:
n
None: No messages are sent.
n
Empty: Send messages with empty fields.
n
Last fix: Send messages with information from the last valid fix.
13. (Optional) For Prepend text, enter text to prepend to the forwarded message. Two variables
can beincluded in the prepended text:
n
%s: Includes the IX20 device's serial number in the prepended text.
n
%v: Includes the vehicle IDin the prepended text.
For example, to include both the device's serial number and vehicle IDin the prepend
message, you can enter the following in the Prepend field:
__|%s|__|%v|__
14. Typea four-digit alphanumeric Vehicle ID that will be included with to location messages. If
no vehicle IDis configured, this setting defaults to 0000.
15. Click Apply to save the configuration and apply the change.
Command line
To Next Page
Loading...
Need help?
General