Services Location information
IX20 User Guide
724
a. Click to expand On exit.
b. (Optional) Enable Bootup action to configure the device to perform the On exit
actionsif the device isinside the geofence when it boots.
c. For Number of intervals, type or select the number of Update Intervalsthat must
take place prior to performing the On exit actions.
For example, if the Update interval is1m (one minute) and the Number of
intervalsis3, the On entry actionswill not be performed until the device has been
inside the geofence for three minutes.
d. Click to expand Actions.
e. Click to create a new action.
f. For Action type, select either:
l
Factory erase to erase the device configuration when the action is triggered.
l
Custom script to execute a custom script when the action is triggered.
If Custom script is selected:
i. Click to expand Custom script.
ii. For Commands, typethe script that will be executed when the action is
triggered. If the script beginswith #!, then the proceeding file path will be used
to invoke the script interpreter. If not, then the default shell will be used.
iii. Enable Log script output to log the output of the script to the system log.
iv. Enable Log script errorsto log errors from the script to the system log.
v. (Optional) For Maximum memory, type the maximum amount of system
memory that will be available for the script and it spawned processes.
Allowed values are any integer followed by oneof the following:
b|bytes|KB|k|MB|M|GB|G|TB|T.
For example. the allocate onemegabyte of memory to the script and its
spawned processes, type 1MBor 1M.
vi. Sandbox is enabled by default. This preventsthe script from adversely
affecting the system. If you disable Sandbox, the script may render the system
unusable.
vii. Repeat for any additional actions.
8. Click Apply to savethe configuration and apply the change.
Command line
To Next Page
Loading...
Need help?
General