Services Location information
IX20 User Guide
729
(config service location geofence test_geofence on_entry action
0)>
where value is either:
l
factory_erase—Erases the device configuration when the action is triggered.
l
script—Executesa custom script when the action is triggered.
factory_erase or script.
If type is set to script:
i. Typeor paste the script, closed in quote marks:
(config service location geofence test_geofence on_entry
action 0)> commands "script"
(config service location geofence test_geofence on_entry
action 0)>
If the script beginswith #!, then the proceeding file path will be used to invoke
the script interpreter. If not, then the default shell will be used.
ii. To log the output of the script to the system log:
(config service location geofence test_geofence on_entry
action 0)> syslog_stdout true
(config service location geofence test_geofence on_entry
action 0)>
iii. To log the errors from the script to the system log:
(config service location geofence test_geofence on_entry
action 0)> syslog_stderr true
(config service location geofence test_geofence on_entry
action 0)>
iv. (Optional) Set the maximum amount of system memory that will be available
for the script and it spawned processes:
(config service location geofence test_geofence on_entry
action 0)> max_memory value
(config service location geofence test_geofence on_entry
action 0)>
where value is any integer followed by one of the following:
b|bytes|KB|k|MB|M|GB|G|TB|T.
For example. the allocate onemegabyte of memory to the script and its
spawned processes:
(config service location geofence test_geofence on_entry
action 0)> max_memory 1MB
(config service location geofence test_geofence on_entry
action 0)>
To Next Page
Loading...
Need help?
General