Services Modbusgateway
IX20 User Guide
742
where value is any number between 10 millisecondsand one second, and take
the format number{ms|s}.
For example, to set idle_gap to 20 milliseconds, enter 20ms.
v. Set the amount of time to wait before disconnecting the socket when it has
become inactive:
(config service modbus_gateway server test_modbus_server)>
inactivity_timeout value
(config service modbus_gateway server test_modbus_server)>
where value is any number of minutesor secondsup to a maximum of 15
minutes, and takes the format number{m|s}.
For example, to set inactivity_timeout to ten minutes, enter either 10m or
600s:
(config service modbus_gateway server test_modbus_server)>
inactivity_timeout 600s
(config service modbus_gateway server test_modbus_server)>
n
If connection_type is set to serial:
i. Set the serial port:
i. Use the ?to determine available serial ports:
(config service modbus_gateway server test_modbus_
server)> ... serial port ?
Serial
Additional Configuration
-------------------------------------------------------
------------------------
port1 Port 1
(config service modbus_gateway server test_modbus_
server)>
ii. Set the port:
(config service modbus_gateway server test_modbus_
server)> serial port
(config service modbus_gateway server test_modbus_
server)>
ii. Set the packet mode:
(config service modbus_gateway server test_modbus_server)>
serial packet_mode value
(config service modbus_gateway server test_modbus_server)>
where value is either rtu or ascii. The default is rtu.
To Next Page
Loading...
Need help?
General