Applications Configurescriptsto run manually
IX20 User Guide
857
10. Sandbox is enabled by default, which restrictsaccess to the file system and available
commandsthat can be used by the script. This option protectsthe script from accidentally
destroying the system it is running on.
11. Click to enable Once to configure the script to run only once at the specified time.
If Once is enabled, rebooting the device will cause the script to not run again. The only way to
re-run the script is to:
n
Remove the script from the device and add it again.
n
Make a change to the script.
n
Uncheck Once.
12. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a script:
(config)> add system schedule script end
(config system schedule script 0)>
Scheduled scripts are enabled by default. To disable:
(config system schedule script 0)> enable false
(config system schedule script 0)>
4. (Optional) Provide a label for the script.
(config system schedule script 0)> label value
(config system schedule script 0)>
where value is any string. if spacesare used, enclose valuewithin double quotes.
5. Set the run mode to manual:
(config system schedule script 0)> when manual
(config system schedule script 0)>
6. Set the commandsthat will execute the script:
(config system schedule script 0)> commands filename
(config system schedule script 0)>
where filenameis the path and filename of the script, and any related command line
information.
To Next Page
Loading...
Need help?
General