Enterasys D2 D2G124-12P

set garp timer
7-24 802.1Q VLAN Configuration
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Thesettingofthesetimersiscriticalandshouldonlybechangedby personnelfamiliarwiththe
802.1Qstandardsdocumentation,whichisnotsuppliedwiththisdevice.
Examples
ThisexampleshowshowtosettheGARPjointimervalueto100centisecondsforallports:
D2(su)->set garp timer join 100 *.*.*
Thisexampleshowshowtosettheleavetimervalueto300centisecondsforallports:
D2(su)->set garp timer leave 300 *.*.*
Thisexampleshowshowtosettheleavealltimervalueto20000centisecondsforallports:
D2(su)->set garp timer leaveall 20000 *.*.*
leavealltimer‐
value
SetstheGARPleavealltimerincentiseconds(Referto802.1Qstandard.)
port‐string Specifiestheport(s)onwhichtoconfigureGARPtimersettings.Fora
detaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.