Enterasys D2 D2G124-12P

set rmon history
13-6 RMON Configuration
Parameters
Defaults
Ifport‐stringisnotspecified,informationaboutallRMONhistoryentrieswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayRMONhistoryentriesforGigabitEthernetport1inswitch1.
Acontrolentrydisplaysfirst,followedbyactualentriescorrespondingtothecontrolentry.Inthis
case,thedefaultsettingsforentryowner,samplinginterval,andmaximumnumberofentries.
(buckets)havenotbeen
changedfromtheirdefaultvalues.Foradescriptionofthetypesof
statisticsshown,refertoTable 13‐44.
:
D2(su)->show rmon history ge.1.1
Port: ge.1.1
-------------------------------------
Index 1
Owner = monitor
Status = valid
Data Source = ifIndex.1
Interval = 30
Buckets Requested = 50
Buckets Granted = 10
Sample 2779 Interval Start: 1 days 0 hours 2 minutes 22 seconds
Drop Events = 0 Undersize Pkts = 0
Octets = 0 Oversize Pkts = 0
Packets = 0 Fragments = 0
Broadcast Pkts = 0 Jabbers = 0
Multicast Pkts = 0 Collisions = 0
CRC Align Errors = 0 Utilization(%) = 0
set rmon history
UsethiscommandtoconfigureanRMONhistoryentry.
Syntax
set rmon history index [port-string] [buckets buckets] [interval interval] [owner
owner]
Parameters
port‐string (Optional)DisplaysRMONhistoryentriesforspecificport(s).
index‐list Specifiesanindexnumberforthisentry.
port‐string (Optional)Assignsthisentrytoaspecificport.
bucketsbuckets (Optional)Specifies themaximumnumberofentriestomaintain.
intervalinterval (Optional)Specifiesthesamplingintervalinseconds.
ownerowner (Optional)Specifiesanownerforthisentry.