H3C MSR Series

1007
Table 158 Command output
Field
Description
Totally 3 attackers Total number of IPv4 scanning attackers.
IP addr(DslitePeer)
The
IP addr
field displays the IPv4 address of the attacker.
The
DslitePeer
field displays the DS-Lite tunnel source IPv6 address of
the attacker in a DS-Lite network. In other situations, this field displays
hyphens (--).
VPN instance
MPLS L3VPN instance to which the attacker's IPv4 address belongs. If the
IPv4 address is on the public network, this field displays hyphens (--).
Protocol Name of the protocol.
Detected on Where the attack is detected, on the device (
Local
) or an interface.
Duration(min) The amount of time the attack lasts, in minutes.
Related commands
display attack-defense scan victim ip
scan detect
display attack-defense scan attacker ipv6
Use display attack-defense scan attacker ipv6 to display information about IPv6 scanning
attackers.
Syntax
Centralized devices in standalone mode:
display attack-defense scan attacker ipv6 [ interface interface-type interface-number | local ]
[ count ]
Distributed devices in standalone mode/centralized devices in IRF mode:
display attack-defense scan attacker ipv6 [ [ interface interface-type interface-number | local ]
[ slot slot-number ] ] [ count ]
Distributed devices in IRF mode:
display attack-defense scan attacker ipv6 [ [ interface interface-type interface-number | local ]
[ chassis chassis-number slot slot-number ] ] [ count ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
local: Specifies the device.
slot slot-number: Specifies a card by its slot number. This option is available only when you specify
the device or a global interface, such as a VLAN interface or tunnel interface. If you do not specify a
card, this command displays information about IPv6 scanning attackers for all cards. (Distributed
devices in standalone mode.)