408
ipv6 ipv6-address: Specifies the IPv6 address of a user.
Usage guidelines
If you do not specify any parameters, this command displays information about all users in the
password control blacklist.
The users' IP addresses and user accounts are added to the password control blacklist when the
users fail authentication. You can use this command to view information about blacklisted FTP, Web,
and virtual terminal line (VTY) users.
Users accessing the system through the console or AUX interface are not blacklisted for the
following reasons:
• The system is unable to obtain the IP addresses of these users.
• These users are privileged and, therefore, relatively secure to the system.
Examples
# Display password control blacklist information.
<Sysname> display password-control blacklist
Blacklist items matched: 2.
Username: test
IP: 192.168.44.1 Login failures: 1 Lock flag: unlock
Username: jj
IP: 192.168.44.3 Login failures: 3 Lock flag: lock
Table 49 Command output
Blacklist items matched Number of blacklisted users.
IP IP address of the user.
Login failures Number of login failures.
Lock flag
Whether the user account is locked for the user:
• unlock—Not limited.
• lock—Disabled temporarily or permanently, depending on the
password-control login-attempt command.
password-control { aging | composition | history | length }
enable
Use password-control { aging | composition | history | length } enable to enable the password
expiration, composition restriction, history, or minimum length restriction feature.
Use undo password-control { aging | composition | history | length } enable to disable a
password control feature.
Syntax
password-control { aging | composition | history | length } enable
undo password-control { aging | composition | history | length } enable
Default
The password control features (aging, composition, history, and length) are all enabled.
Views
System view
To Next Page
Loading...
