H3C MSR Series

104
If you use both the nas-ip command and radius nas-ip command, the following guidelines apply:
• The setting configured by the nas-ip command in RADIUS scheme view applies only to the
RADIUS scheme.
• The setting configured by the radius nas-ip command in system view applies to all RADIUS
schemes.
• The setting in RADIUS scheme view takes precedence over the setting in system view.
You can specify a maximum of 16 source IP addresses, including the following IP addresses:
• Zero or one public-network source IPv4 address.
• Zero or one public-network source IPv6 address.
• Private-network source IP addresses.
Each VPN instance can have a maximum of one private-network source IPv4 address and one
private-network source IPv6 address.
Examples
# Specify IP address 129.10.10.1 as the source address for outgoing RADIUS packets.
<Sysname> system-view
[Sysname] radius nas-ip 129.10.10.1
Related commands
nas-ip (RADIUS scheme view)
radius scheme
Use radius scheme to create a RADIUS scheme and enter its view, or enter the view of an existing
RADIUS scheme.
Use undo radius scheme to delete a RADIUS scheme.
Syntax
radius scheme radius-scheme-name
undo radius scheme radius-scheme-name
Default
No RADIUS schemes exist.
Views
System view
Predefined user roles
network-admin
Parameters
radius-scheme-name: Specifies the RADIUS scheme name, a case-insensitive string of 1 to 32
characters.
Usage guidelines
A RADIUS scheme can be used by more than one ISP domain at the same time.
The device supports a maximum of 16 RADIUS schemes.
Examples
# Create a RADIUS scheme named radius1 and enter RADIUS scheme view.
<Sysname> system-view