900
Application
Application layer protocol, FTP or DNS.
If it is an unknown protocol identified by an unknown port, this field displays
OTHER
.
Start time Time when the multicast session was created.
TTL Remaining lifetime of the multicast session, in seconds.
Inbound interface Inbound interface of the first packet from the initiator to responder.
Outbound interface Outbound interface of the first packet from the initiator to responder.
Outbound interface list Outbound interfaces of the first packet from the initiator to responder.
Source security zone
Security zone to which the inbound interface belongs. If the inbound
interface does not belong to any security zone, this field displays a hyphen
(-).
Destination security zone
Security zone to which the outbound interface belongs. If the outbound
interface does not belong to any security zone, this field displays a hyphen
(-).
Initiator->Responder Number of packets and bytes from the initiator to the responder.
Total sessions found Total number of found multicast session entries.
reset session relation-table
Use reset session relation-table to clear relation entries.
Syntax
Centralized devices in standalone mode:
reset session relation-table [ ipv4 | ipv6 ]
Distributed devices in standalone mode/centralized devices in IRF mode:
reset session relation-table [ ipv4 | ipv6 ] [ slot slot-number ]
Distributed devices in IRF mode:
reset session relation-table [ ipv4 | ipv6 ] [ chassis chassis-number slot slot-number ]
Views
User view
Predefined user roles
network-admin
Parameters
ipv4: Specifies IPv4 relation entries.
ipv6: Specifies IPv6 relation entries.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
clears relation entries for all cards. (Distributed devices in standalone mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command clears relation entries for all member devices. (Centralized devices in IRF
mode.)
chassis chassis-number slot slot-number: Specifies a card on a member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number