1030
<Sysname> display blacklist ipv6 count
Slot 1 in chassis 1:
Totally 3 blacklist entries.
Slot 2 in chassis 2:
Totally 3 blacklist entries.
Table 166 Command output
IPv6 address IPv6 address of the blacklist entry.
VPN instance
MPLS L3VPN instance to which the blacklisted IPv6 address belongs. If
the blacklisted IPv6 address is on the public network, this field displays
hyphens (--).
Type Type of the IPv6 blacklist entry,
Manual
or
Dynamic
.
TTL(sec)
Remaining aging time of the IPv6 blacklist entry, in seconds. If no aging
time is set for the entry, this field displays
Never
.
Dropped Number of dropped packets sourced from the IPv6 address.
Totally 3 blacklist entries Total number of IPv6 blacklist entries.
Related commands
blacklist ipv6
display client-verify protected ip
Use display client-verify protected ip to display protected IPv4 addresses for client verification.
Syntax
Centralized devices in standalone mode:
display client-verify { dns | http | tcp } protected ip [ ip-address [ vpn vpn-instance-name ] ] [ port
port-number ] [ count ]
Distributed devices in standalone mode/centralized devices in IRF mode:
display client-verify { dns | http | tcp } protected ip [ ip-address [ vpn vpn-instance-name ] ] [ port
port-number ] [ slot slot-number ] [ count ]
Distributed devices in IRF mode:
display client-verify { dns | http | tcp } protected ip [ ip-address [ vpn vpn-instance-name ] ] [ port
port-number ] [ chassis chassis-number slot slot-number ] [ count ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
dns: Specifies the DNS client verification feature.
http: Specifies the HTTP client verification feature.
tcp: Specifies the TCP client verification feature.
To Next Page
Loading...
Need help?
General
