367
Usage guidelines
This feature logs information about portal redirect packets, including the user IP address, MAC
address, SSID, BAS IP, and Web server IP address. For portal log messages to be sent correctly,
you must also configure the information center on the device. For more information about information
center configuration, see Network Management and Monitoring Configuration Guide.
Examples
# Enable logging for portal redirect.
<Sysname> system-view
[Sysname] portal redirect log enable
Related commands
portal packet log enable
portal user log enable
portal refresh enable
Use portal refresh { arp | nd } enable to enable ARP or ND entry conversion for portal clients.
Use undo portal refresh { arp | nd } enable to disable ARP or ND entry conversion for portal clients.
Syntax
portal refresh { arp | nd } enable
undo portal refresh { arp | nd } enable
Default
ARP and ND entry conversion features are enabled for portal clients.
Views
System view
Predefined user roles
network-admin
Parameters
arp: Specifies the ARP entries.
nd: Specifies the ND entries.
Usage guidelines
After you enable this feature:
• ARP or ND entries for portal users who pass authentication after this feature is enabled are
converted to Rule ARP or ND entries. Rule ARP or ND entries will not be aged.
• ARP or ND entries for portal users who pass authentication before this feature is enabled will be
aged when their respective aging timers expire.
After you disable this feature:
• ARP or ND entries for portal users who pass authentication after this feature is disabled will be
aged when their respective aging timers expire.
• Rule ARP or ND entries created for portal users before this feature is disabled are still Rule ARP
or ND entries.
Examples
# Disable ARP entry conversion for portal clients.
<Sysname> system-view
To Next Page
Loading...
Need help?
General
