1
AAA commands
The device supports the FIPS mode that complies with NIST FIPS 140-2 requirements. Support for
features, commands, and parameters might differ in FIPS mode and non-FIPS mode. For more
information about FIPS mode, see Security Configuration Guide.
IPv6-related parameters are not supported on the following routers:
• MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM-HK/810-W-LM-HK/810-L
MS/810-LUS.
• MSR3600-28-SI/3600-51-SI.
General AAA commands
aaa nas-id profile
Use aaa nas-id profile to create a NAS-ID profile and enter its view, or enter the view of an existing
NAS-ID profile.
Use undo aaa nas-id profile to delete a NAS-ID profile.
Syntax
aaa nas-id profile profile-name
undo aaa nas-id profile profile-name
Default
No NAS-ID profiles exist.
Views
System view
Predefined user roles
network-admin
Parameters
profile-name: Specifies the NAS-ID profile name, a case-insensitive string of 1 to 31 characters.
Usage guidelines
Configure a NAS-ID profile to maintain NAS-ID and VLAN bindings on the device.
Examples
# Create a NAS-ID profile named aaa.
<Sysname> system-view
[Sysname] aaa nas-id profile aaa
[Sysname-nas-id-prof-aaa]
Related commands
nas-id bind vlan
port-security nas-id-profile
portal nas-id-profile
To Next Page
Loading...
