883
Start time: 2011-07-29 19:12:33 TTL: 55s
Initiator->Responder: 1 packets 60 bytes
Responder->Initiator: 0 packets 0 bytes
Total sessions found: 2
Table 138 Command output
Initiator Information about the unicast session from the initiator to the responder.
Responder Information about the unicast session from the responder to the initiator.
DS-Lite tunnel peer
Address of the DS-Lite tunnel peer.
When the unicast session does not belong to any DS-Lite tunnel, this field
displays a hyphen (-).
VPN instance/VLAN ID/Inline
ID
MPLS L3VPN instance to which the unicast session belongs.
VLAN and inline to which the session belongs during Layer 2 forwarding.
If a parameter is not specified, a hyphens (-) is displayed for the proper
field.
Protocol
Transport layer protocol:
• DCCP.
• ICMP.
• ICMPv6.
• Raw IP.
• SCTP.
• TCP.
• UDP.
• UDP-Lite.
The number in the brackets indicates the protocol number.
Source security zone
Security zone to which the inbound interface belongs. If the inbound
interface does not belong to any security zone, this field displays a hyphen
(-).
State Unicast session state.
Application
Application layer protocol, FTP or DNS.
If it is an unknown protocol identified by an unknown port, this field displays
OTHER
.
Start time Unicast session establishment time.
TTL Remaining lifetime of the unicast session, in seconds.
Initiator->Responder Number of packets and bytes from the initiator to the responder.
Responder->Initiator Number of packets and bytes from the responder to the initiator.
Total sessions found Total number of found unicast session entries.
display session table ipv6
Use display session table ipv6 to display information about IPv6 unicast session entries that match
specific criteria.
Syntax
Centralized devices in standalone mode:
To Next Page
Loading...
Need help?
General
