H3C MSR Series Command Reference

556
local-address
reset ipsec sa
Use reset ipsec sa to clear IPsec SAs.
Syntax
reset ipsec sa [ { ipv6-policy | policy } policy-name [ seq-number ] | profile policy-name | remote
{ ipv4-address | ipv6 ipv6-address } | spi { ipv4-address | ipv6 ipv6-address } { ah | esp } spi-num ]
Views
User view
Predefined user roles
network-admin
Parameters
{ ipv6-policy | policy } policy-name [ seq-number ]: Clears IPsec SAs for the specified IPsec policy.
• ipv6-policy: Specifies an IPv6 IPsec policy.
• policy: Specifies an IPv4 IPsec policy.
• policy-name: Specifies the name of the IPsec policy, a case-insensitive string of 1 to 63
characters.
• seq-number: Specifies the sequence number of an IPsec policy entry, in the range of 1 to
65535. If you do not specify this argument, all the entries in the IPsec policy are specified.
profile profile-name: Clears IPsec SAs for the IPsec profile specified by its name, a case-insensitive
string of 1 to 63 characters.
remote: Clears IPsec SAs for the specified remote address.
• ipv4-address: Specifies a remote IPv4 address.
• ipv6 ipv6-address: Specifies a remote IPv6 address.
spi { ipv4-address | ipv6 ipv6-address } { ah | esp } spi-num ]: Clears IPsec SAs matching the
specified SA triplet: the remote address, the security protocol, and the SPI.
• ipv4-address: Specifies a remote IPv4 address.
• ipv6 ipv6-address: Specifies a remote IPv6 address.
• ah: Specifies the AH protocol.
• esp: Specifies the ESP protocol.
• spi-num: Specifies the security parameter index in the range of 256 to 4294967295.
Usage guidelines
If you do not specify any parameters, this command clears all IPsec SAs.
If you specify an SA triplet, this command clears the IPsec SA matching the triplet, and all the other
IPsec SAs that were established during the same negotiation process, including the corresponding
IPsec SA in the other direction, and the inbound and outbound IPsec SAs using the other security
protocol (AH or ESP).
An outbound SA is uniquely identified by an SA triplet and an inbound SA is uniquely identified by an
SPI. To clear IPsec SAs by specifying a triplet in the outbound direction, you should provide the
remote IP address, the security protocol, and the SPI, where the remote IP address can be any valid
address if the SAs are established by IPsec profiles. To clear IPsec SAs by specifying a triplet in the
inbound direction, you should provide the SPI and use any valid values for the other two parameters.

H3C MSR Series Specifications

General

Category	Network Router
IPv6 Support	Yes
Dimensions	Varies by model
Weight	Varies by model
Product Type	Modular Router
Ports	Varies by model
WAN Interfaces	Varies by model
Firewall	Yes
QoS	Yes
Wireless Support	Varies by model
USB Ports	Varies by model
Console Port	Yes
Power Supply	Varies by model
Redundancy	Varies by model
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% non-condensing
Series	MSR
Certifications	CE, FCC, RoHS