976
Default
No attack defense policy is applied to an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
policy-name: Specifies an attack defense policy by its name. The policy name is a case-insensitive
string of 1 to 31 characters. Valid characters include uppercase and lowercase letters, digits,
underscores (_), and hyphens (-).
Usage guidelines
An interface can have only one attack defense policy applied. If you execute this command multiple
times, the most recent configuration takes effect.
An attack defense policy can be applied to multiple interfaces.
Examples
# Apply the attack defense policy atk-policy-1 to interface GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] attack-defense apply policy atk-policy-1
Related commands
attack-defense policy
display attack-defense policy
attack-defense local apply policy
Use attack-defense local apply policy to apply an attack defense policy to the device.
Use undo attack-defense local apply policy to restore the default.
Syntax
attack-defense local apply policy policy-name
undo attack-defense local apply policy
Default
No attack defense policy is applied to the device.
Views
System view
Predefined user roles
network-admin
Parameters
policy-name: Specifies an attack defense policy by its name. The policy name is a case-insensitive
string of 1 to 31 characters. Valid characters include uppercase and lowercase letters, digits,
underscores (_), and hyphens (-).
To Next Page
Loading...
