959
x packets,y bytes
The rule has matched x packets, a total of y bytes. This field
is displayed only when the following conditions exist:
• The counting or logging keyword is specified in the
rule command.
• The rule has been matched.
Related commands
reset object-policy statistics
display object-policy zone-pair security
Use display object-policy zone-pair security to display information about the object policies
applied to zone pairs.
Syntax
display object-policy zone-pair security [ source source-zone-name destination
destination-zone-name ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
source source-zone-name: Specifies a source security zone name, a case-insensitive string of 1 to
31 characters.
destination destination-zone-name: Specifies a destination security zone name, a case-insensitive
string of 1 to 31 characters.
Usage guidelines
If you do not specify a zone pair, the system displays information about the object policies applied to
all zone pairs.
Examples
# Display information about the object policies applied to all zone pairs.
<Sysname> display object-policy zone-pair security
Zone-pair source office destination library
object-policy apply ip permit
object-policy apply ipv6 drop
Table 151 Command output
Zone-pair source office destination library Name of the zone pair.
object-policy apply ip permit Name of the IPv4 object policy applied to the zone pair.
object-policy apply ipv6 drop Name of the IPv6 object policy applied to the zone pair.
To Next Page
Loading...
Need help?
General
