341
Predefined user roles
network-admin
Parameters
ipv6: Specifies IPv6 portal Web servers. To specify IPv4 portal Web servers, do not specify this
keyword.
Usage guidelines
The following matrix shows the support of the MSR routers for this command in different views:
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-
10-PoE/810-LM-HK/810-W-LM-HK
Yes Yes
MSR810-LMS/810-LUS Yes No
MSR2600-10-X1 Yes Yes
MSR 2630 Yes Yes
MSR3600-28/3600-51 Yes Yes
MSR3600-28-SI/3600-51-SI Yes No
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP
-DC
Yes No
MSR 3610/3620/3620-DP/3640/3660 Yes Yes
MSR5620/5660/5680 Yes No
On an interface or service template enabled with portal fail-permit for a portal authentication server
and portal Web servers, portal authentication becomes disabled in either of the following conditions:
• All portal Web servers are unreachable.
• The specified portal authentication server is unreachable.
Portal authentication resumes when the specified portal authentication server and a minimum of one
portal Web server becomes reachable. After portal authentication resumes, users who failed portal
authentication and unauthenticated portal users need to pass authentication to access network
resources. Portal users who have passed authentication can continue accessing network resources.
On the same interface or service template, the portal Web server is unreachable when both the
primary and backup portal Web servers are unreachable.
Before you configure this feature for a service template, make sure the service template is disabled.
Examples
# Enable portal fail-permit for the portal Web servers on service template service1.
<Sysname> system-view
[Sysname] wlan service-template service1
[Sysname-wlan-st-service1] portal fail-permit web-server
Related commands
display portal
portal free-all except destination
Use portal free-all except destination to configure an IPv4 portal authentication destination subnet
on an interface.
To Next Page
Loading...
Need help?
General
