773
Default
No WINS servers are specified for IP access.
Views
SSL VPN context view
Predefined user roles
network-admin
Parameters
primary: Specifies the primary WINS server.
secondary: Specifies the secondary WINS server.
ip-address: Specifies the IPv4 address of the WINS server. It cannot be a multicast, broadcast, or
loopback address.
Examples
# Specify the primary WINS server 1.1.1.1 for IP access.
<Sysname> system-view
[Sysname] sslvpn context ctx
[Sysname-sslvpn-context-ctx] ip-tunnel wins-server primary 1.1.1.1
ipv6 address
Use ipv6 address to configure an IPv6 address and a port number for an SSL VPN gateway.
Use undo ipv6 address to restore the default.
Syntax
ipv6 address ipv6-address [ port port-number ]
undo ipv6 address
Default
No IPv6 address is specified for an SSL VPN gateway.
Views
SSL VPN gateway view
Predefined user roles
network-admin
Parameters
ipv6-address: Specifies an IPv6 address for the SSL VPN gateway, a 16-byte hexadecimal string
separated by colons.
port port-number: Specifies a port number for the SSL VPN gateway. The port number is 443 (the
default value) or in the range of 1025 to 65535.
Usage guidelines
A remote user uses the IPv6 address and port number configured by this command to access an
SSL VPN gateway.
The specified IPv6 address must be the address of an interface on the gateway device and is
reachable from clients and internal servers.
Do not use the management address of the device as the IPv6 address of the SSL VPN gateway.
If you execute this command multiple times, the most recent configuration takes effect.
To Next Page
Loading...
Need help?
General
