916
Views
System view
Predefined user roles
network-admin
Parameters
time-value: Specifies the interval in minutes. The value range for the time-value argument is 10 to
120 and the value must be integer times of 10.
Usage guidelines
If you set both time-based and traffic-based logging, the device outputs a session log when
whichever is reached. After outputting a session log, the device resets the traffic counter and restarts
the interval for the session.
Examples
# Configure the device to output session logs every 50 minutes.
<Sysname> system
[Sysname] session log time-active 50
Related commands
session log enable
session log bytes-active
session log packets-active
session persistent acl
Use session persistent acl to specify persistent sessions.
Use undo session persistent acl to restore the default.
Syntax
session persistent acl [ ipv6 ] acl-number [ aging-time time-value ]
undo session persistent acl [ ipv6 ] acl-number
Default
No persistent sessions exist.
Views
System view
Predefined user roles
network-admin
Parameters
ipv6: Specifies an IPv6 ACL. To specify an IPv4 ACL, do not specify this keyword.
acl-number: Specifies an ACL by its number in the range of 2000 to 3999.
aging-time time-value: Specifies the aging time for persistent sessions in hours. The value range for
the time-value argument is 0 to 360, and the default value is 24. To disable the aging for persistent
sessions, set the value to 0.
Usage guidelines
This command is effective only on TCP sessions in ESTABLISHED state.
To Next Page
Loading...
Need help?
General
