121
Parameters
data { byte | giga-byte | kilo-byte | mega-byte }: Specifies the unit for data flows, which can be
byte, kilobyte, megabyte, or gigabyte.
packet { giga-packet | kilo-packet | mega-packet | one-packet }: Specifies the unit for data
packets, which can be one-packet, kilo-packet, mega-packet, or giga-packet.
Usage guidelines
The data flow and packet measurement units for traffic statistics must be the same as configured on
the HWTACACS accounting servers. Otherwise, accounting results might be incorrect.
Examples
# In HWTACACS scheme hwt1, set the data flow and packet measurement units for traffic statistics
to kilobyte and kilo-packet, respectively.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] data-flow-format data kilo-byte packet kilo-packet
Related commands
display hwtacacs scheme
display hwtacacs scheme
Use display hwtacacs scheme to display the configuration or statistics of HWTACACS schemes.
Syntax
display hwtacacs scheme [ hwtacacs-scheme-name [ statistics ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
hwtacacs-scheme-name: Specifies an HWTACACS scheme by its name, a case-insensitive string of
1 to 32 characters. If you do not specify an HWTACACS scheme, this command displays the
configuration of all HWTACACS schemes.
statistics: Displays the HWTACACS service statistics. If you do not specify this keyword, the
command displays the configuration of the HWTACACS scheme.
Examples
# Displays the configuration of all HWTACACS schemes.
<Sysname> display hwtacacs scheme
Total 1 HWTACACS schemes
------------------------------------------------------------------
HWTACACS Scheme Name : hwtac
Index : 0
Primary Auth Server:
IP : 2.2.2.2 Port: 49 State: Active
VPN Instance: 2
To Next Page
Loading...
