957
Object-policy accelerated
Rule matching acceleration is enabled for the IPv4 object
policy.
rule 5 pass source-ip sourceip
Statement of rule 5. The value of
sourceip
is the name of the
source IPv4 address object group.
rule 5 comment This rule is used for
source-ip sourceip
Description of rule 5.
display object-policy ipv6
Use display object-policy ipv6 to display information about IPv6 object policies.
Syntax
display object-policy ipv6 [ object-policy-name ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
object-policy-name: Specifies an object policy by its name, a case-insensitive string of 1 to 63
characters. If you do not specify an object policy name, this command displays information about all
IPv6 object policies.
Usage guidelines
This command displays IPv6 object policy rules in the order they were configured.
Examples
# Display information about all IPv6 object policies.
<Sysname> display object-policy ipv6
Object-policy ipv6 pass
This is an IPv6 object policy for the zone-pair security source office destination library
Object-policy accelerated
rule 5 pass source-ip sourceipv6
rule 5 comment This rule is used for source-ip sourceipv6
Table 149 Command output
Object-policy ipv6 pass Name of the IPv6 object policy.
This is an IPv6 object policy for the
zone-pair security source office destination
library
Description of the IPv6 object policy.
Object-policy accelerated
Rule matching acceleration is enabled for the IPv6 object
policy.
rule 5 pass source-ip sourceipv6
Statement of rule 5. The value of
sourceipv6
is the name of
the source IPv6 address object group.